Library
Articles
Pricing
Faculty
AudioPedia
Support
Login
Sign Up
Share
Go
or browse by category
Audio
Video
Graphics
Productivity
Web
Take a 22 question quiz to test and certify your knowledge of the tutorial-video course
Pro Tools 105 - Mastering Essentials.
Get a mark of 80% or higher to pass this quiz!
1
M-S processing converts L/R stereo audio to...
a Mid (sum) channel and a Sides (difference) channel
a mono signal to stereo
5.1 surround audio with simulated rear channel ambience
a Max (high-level) channel and a Soft (low-level) channel
2
The new level scale used for Loudness Normalization is...
the dBu scale
the dBspl scale
the dB scale
the LUFS scale
3
To comply with most modern Loudness standards, a good setting would be...
a ceiling of -1dBTP
a ceiling of -.3dBfs
a ceiling of 10 dBfs
a ceiling of -14 dBfs
4
When A/B'ing the masters-in-progress against commercial reference tracks...
the masters-in-progress should always be 6dB louder than the reference tracks
the average levels should be level-matched for valid comparison
the masters and reference tracks should be played simultaneously
you should never A/B your track against commercial releases
5
An Offline Bounce...
renders the new file in real time while playing the audio
should be avoided
renders the new file silently in faster-then-real time
can only be done when disconnected from the internet
6
Pro Tools' included EQs are:
linear-phase EQs
standard minimum-phase EQs
dynamic EQs
switchable between minimum-phase & linear-phase
7
Which of the following compressors is included with Pro Tools?
Compressor/Limiter III, Channel Strip Compressor and BF-76
Channel Strip Compressor
BF-76
Compressor/Limiter III
8
When EQ'ing, a smile curve is...
a great-sounding EQ guaranteed to make the listener smile
a broad midrange boost centered around 1kHz
the application of both highpass & lowpass filters
a broad, gentle boost of the highs & lows
9
In a typical mastering session...
you should never A/B the song against other songs during mastering
you might work on EQ & compression before applying brickwall limiting
you must always apply brickwall limiting before setting the other processing
you should apply reverb first
10
A standard chain for mastering processing would be:
EQ, Delay, Reverb
EQ, Compression, Limiting
EQ, Comrpession, Reverb
EQ, Limiting, Reverb
11
Character processors are typically plug-ins that...
special effect processors that are applied on top of standard processing
remotely control an actual external hardware unit
emulate the sound & response of analog hardware
are designed by famous engineers
12
In the analog era, mastering was primarily done to...
transfer a mix from vinyl to tape
create hotter CDs
transfer a mix from tape to vinyl
create a stereo mix from a mono mix
13
Two additional processors that might be used in mastering are...
a chorus and a flanger
delay and reverb
an enhancer and a slap echo
an exciter and a reverb
14
Mastering activities that can be performed in Pro Tools include:
EQ, compression, brickwall limiting, multiband compression, and M-S processing
multiband compression
EQ, compression, and brickwall limiting
M-S processing
15
A common approach to mastering compression uses...
a very high Threshold and a very fast Attack
a very high Ratio and a very fast Attack
lower Ratio and lower Threshold settings
stacking 5 compressors in a row
16
A brickwall limiter...
absolutely cuts the audio below a set frequency, before limiting
absolutely cuts the audio above a set frequency, before limiting
absolutely prevents the signal from exceeding a set Threshold
is used for brick wall limiting
17
What is Mastering?
A processing only done for analog media
The final stage of audio production
The same as Mixing
The process of duplicating a final mix
18
A vectorscope displays:
the average loudness over the length of the song
the instantaneous level of an audio signal that is passing through
the dynamic frequency balance of the song
the relative phase between the left and right channels
19
Multiband compression...
applies independent compression in several frequency bands
is used place of a saturator
chains several mastering compressors in sequence
is used in place of brickwall limiting
20
The best approach to mastering multiple songs is to...
use a separate chain of mastering processors for each song
use the same chain of mastering processors for all the songs
open each song in a separate Pro Tools session
master all the song in the same project
21
In the Avid Pro Multiband compressor, Slope...
is a smiling EQ
is a combined Attack/Release control
is a frequency tilt EQ to augment the compression
is a combination Ratio/Knee control
22
You can implement M-S processing in Pro Tools by...
Pro Tools does not include any M-S plug-ins so it can't be done
M/S processing is a myth. It doesn't exist.
inserting multi-mono plug-ins between LR->MS and MS->LR plug-ins
exporting the audio to a third-party standalone M-S application
Pro Tools 105
Mastering Essentials
You have answered
0
out of 22
questions.
You must
login
to take this quiz.
If you do not have an account, please
sign up
.
Get Your Grade
Cancel Quiz
Nice try! Unfortunately you didn't have enough correct answers to pass the quiz. No sweat! You can retake a quiz once per day.
-
-
You need 80% to pass this quiz
Retake Quiz
Back to the Course
View My Grades
Feedback
How are we doing?
We'd love your thoughts, feedback and questions regarding our new site. All feedback is appreciated!
We do not respond to this form! If you need support, please visit our
support page
.
Thank you for your input!
Your message has been successfully sent
Course Advisor
Don't Know Where To Start?
Ask A Course Advisor
Ask Us!
Copy the link below and paste it into an email, forum, or Facebook to share this with your friends.
copy
Make money when you share our links
Become an Ask.Video Affiliate!
The current affiliate rate is: 50%
Sign Up
Facebook
Twitter
Linkedin
Google+
Reddit
Pinterest
Classes Start Next Week!
Live 8-week Online Certification Classes for:
Logic Pro
Learn More
Ableton Live
Learn More
Bitwig
Learn More
